Wiring Harness Conversion Service - Gen4 / Gen5 3SGTE – TCS
$ 238.99 · 5 (750) · In stock
The most important part of any engine swap into your Toyota MR2 is wiring. We spend countless hours fixing wiring harness work on these swaps when customers decide they want to perform the wiring conversion themselves. Save yourself a TON of time and headache, and just send it to the professionals. Please Note: The additional cost for the Gen5 3SGTE swaps is to remove the factory immobilizer that is built into the Gen5 ECU. Without this service, your car will NOT start. Upon ordering, you will need to send us the following: 1. Your original engine harness (the one that is currently running your car) 2. Your Gen4 or Gen5 engine harness 3. Your Gen5 ECU (if you selected Gen5 3SGTE swap) In roughly 2 weeks you will receive back a fully plug and play engine
Gen V Standalone Harness (4 WIRE FUEL RAIL PRESSURE SENSOR) 2014
Intercooler COMPLETE kit - Gen4 Gen5 3SGTE – Prime MR2
Blog - ATS Racing
TCS Motorsports - Fresh gen5 3SGTE swap about to head back to
Gen5 ST246 3SGTE Swap MR2 Owners Club Forum
1999 - 2003 Vortec W/ 4L60E Standalone Wiring Harness (DBC)
The most critical conversion part you need when performing an engine swap is a plug and play engine wire harness. Believe us when we tell you, the
Wire Harness Conversions
Wiring harness information for 2007 up vortec Gen IV truck harnesses
Intercooler Piping Kit - Gen2 / Gen3 / Gen4 / Gen5 3SGTE – Prime MR2
Intercooler Piping Kit - Gen2 / Gen3 / Gen4 / Gen5 3SGTE – Prime MR2
LT1/LT4/Ecotec3 Gen V Swap Harnesses Now Available! - Howell EFI
Blog - ATS Racing